Error Correction - Siku CONTROL32 6769 Mode D'emploi

FAULT
No connection is established between the hand-held
transmitter and the vehicle.
There are functional faults at the vehicle (jerky rear
coupling, engine moves without actuation of the
corresponding buttons on the hand-held transmitter).
The corresponding level button is not shining even
though there is a connection to the vehicle.
The corresponding level button is shining, though there
is no connection with the vehicle.
When running through the saved models a connection
cannot be established.
Vehicle makes muffled clicking sounds when under
great strain.
CAUSE
Battery / battery voltage too low.
Transmission fault.
Battery / battery voltage too low.
Transmission fault.
Transmission error
(The vehicle could not be allocated
to the corresponding level).
Transmission error (The vehicle could be allocated
to the corresponding level but could not establish
a connection).
Connection / transmission error
All drives are equipped with internal sliding clutches
which protect the user from injury and the drives
concerned from being damaged when they are
under a great load or when an external force
applied is too large.

ERROR CORRECTION

Change /charge the (rechargeable) batteries in the
hand-held transmitter.
Change /charge the rechargeable batteries in the vehicle.
Turn on and off or scan at hand-held transmitter
(establishment of new connection).
Turn the vehicle on and off.
Change /charge the (rechargeable) batteries in the
hand-held transmitter.
Change /charge the rechargeable batteries in the vehicle.
Turn on and off or scan at hand-held transmitter
(establishment of new connection).
Turn the vehicle on and off.
Turn on and off or scan at hand-held transmitter
(establishment of new connection).
Turn the vehicle on and off.
Although the corresponding level button is not shining,
the model is fully functional.
Turn on and off or scan at hand-held transmitter
(establishment of new connection).
Turn the vehicle off and on.
Press the corresponding level buttons again.
Otherwise turn off and back on or scan at the hand-held
transmitter (establishment of new connection).
Turn the vehicle on and off.
Is not a fault but a safety precaution.