Siku CONTROL32 6769 Mode D'emploi page 14

1 Is the vehicle switched on? Move switch from OFF to ON
2 Is the light flashing constantly? Step 3.
3 Is the battery securely in the compartment? Pull out battery and put back into compartment
securely. Then repeat step 2.
4 Is the battery charged? Put the battery into Step 5.
the charging pod.
Is the control light red?
5 Is the control light on the charger with the Step 6.
battery shining green continually?
6 Is the control light on the power supply plug Plug in power supply unit.
shining red or green or is the power supply
plug in the socket?
7 Is the hand-held transmitter switched on? Press control light.
Control light is shining.
8 Is the control light on? Step 9.
9 Are the batteries inserted correctly? Put in the batteries correctly.
Check directions given in the
battery compartment!
10 Switching on the hand-held transmitter. Turn hand-held transmitter and vehicle off and
Switching on the vehicle. back on.
Is the corresponding level button shining?
11 Does the vehicle respond? Repeat step 10.
Otherwise, contact the service department.
NO YES
Step 2.
Step 7.
Step 4.
Battery is charging. If the control light is continually shining
green, then charging has finished. Put battery into the
compartment of the vehicle and repeat step 2.
Put the battery firmly into the charger again. If the control light
is shining red, then the battery is charging. If afterwards it is
shining green, then charging is complete. Put battery into the
compartment of the vehicle and repeat step 2.
Contact the service department
Step 8.
Step 10.
Insert full batteries. If the SIKU control light still does not
light up: Contact the service department.
Step 11.