Technical Specifications; First Aid; Error Correction - Siku 2466 Mode D'emploi

Please read the operating instructions before use
and keep them in a safe place.
Made in Germany
Sieper GmbH
Schlittenbacher Str. 60
58511 Lüdenscheid
Germany
www.siku.de

First aid

Here is a list which may help you correct any faults that may occur:
1 Turn on model, switch to ON
position. Is the conveyor belt
running?
2 Are the batteries the right way
round in their compartment?
3 Are the batteries full?
FAQ
You can find a few fault descriptions here:
FAULT
The conveyor belt does not move
or only in a sluggish fashion even
though the motor is running.
The conveyor belt does not move
or only in a sluggish fashion;
cracking noises audible.
Conveyor belt keeps wandering
off to one of the side walls.

Technical Specifications

Model
Material
Dimensions
Generating sets
Energy supply:
Weight
Conveying velocity
NO
Step 2
Unscrew fastening screw and remove battery compart-
ment lid. Put in the batteries the right way round.
Finally, put on the battery compartment lid and fix with
the fastening screw. Repeat step 1.
Unscrew fastening screw and remove battery compart-
ment lid. Put in new or full batteries the right way round.
Finally, put on the battery compartment lid and fix with
the fastening screw. Repeat step 1.
CAUSE
Tension of the conveyor belt
too low.
Overload safety device
(friction clutch) engages.
The tension roller is fixed in
a slanted position.
Metal with plastic parts
360 x 100 x 100 mm
1 Drive motor
2 x AAA batteries (1.5 V)
approx. 400 g
(without batteries and
accessories)
approx. 70 mm/s
YES
Step 3
Contact the service
department

ERROR CORRECTION

Increase the conveyor belt tension.
See description
"Tightening the conveyor belt"
Reduce conveyor belt tension
See description
"Tightening the conveyor belt"
Shift the position of the tension roller evenly
on both sides.
See description
"Tightening the conveyor belt"
9