Boston Scientific Precision SCS Mode D'emploi page 5

Battery removal is recommended if the
Remote Control is not going to be used for an
extended period of time.
1. On the rear of
the Remote
Control, push
in slightly and
slide the battery
compartment
cover down.
2. Remove the old
batteries.
3. Place the new batteries in the slots by
matching the positive (+) and negative (–)
battery ends with the + / – markings in the
compartment.
4. Align the cover on the case and slide the
cover into position until it snaps closed.
General Instructions
1. To turn stimulation on or off, press the
button.
NOTE:
• When it has not been used for
approximately one minute, the Remote
Control sets itself in a sleep/idle mode
and the display screen is blank. At this
time, the keys become locked. When you
press any button except the
Remote Control will display the following
message:
• To reactivate (unlock) the Remote Control,
press and hold
screen appears.
!
! button, the
General Instructions
P
until the following
Physician Trial Kit Insert
90877412-04 REV A 3 of 94
3