Rizzoli S Manuel D'utilisation page 99

4.8 PLATE CLEANING AND MAINTENANCE
Radiating plates in special steel need regular
maintenance, in particular they need clean-
ing after every use that brings moisture or
dust on the plate itself. You should clean the
plate when it is tepid, so that the moisture
vanish for evaporation and rust stains do
not occur.
Do not clean the wood fired cooker with
water when the wood fired cooker is cold.
Moreover, it is important to be sure that the
expansion cuts and the hole between the
plate and the frame are not obstructed by
dust or by other residuals: the plate could
suffer deformations, also permanent. When
it is necessary, you should clean also the
beating of the circled removing eventual
residuals. The plates are all worked in with
non acid anti-corrosion oil. The use of the
wood fired cooker deletes this oil layer and
so the contact with water may cause small
rusty stains. In this case you have to wipe the
4.9 MAINTENANCE OF THE LIGHT (S 60 CF, S 80, S 90)
WARNING! Before starting any maintenance operation for the light, you must
disconnect it from AC power and be sure that the wood fired cooker is not
powered. Be sure that no tension is in the device. Verify also if the wood fired
cooker is cold and if the light was turned on in the previous minutes.
Oven lamp suffers high temperatures. Even
if it is designed to work in these conditions,
it could become out of order. You have to
replace it with a lamp with the same fea-
tures (halogen lamp 25W 230V 300° connec-
tion G9). To replace the lamp you have to
unscrew the lamp cover, remove the lamp,
Picture 33 - Removal of the oven lamp
plate with a rag soaked with non acid oil.
If the rusty stain is not being cleaned, you
could have to wipe the plate with a lightly
abrasive paper or with the abrasive sponge
given together with the wood fired cook-
er. To restore the protecting layer wipe the
plate with little oil.
Radiating steel plates, exposed to contin-
uous heating, trend slowly to take a bur-
nished colour; if you want to accelerate the
process, repeat frequently the oil wiping.
Together with the wood fired cooker are
given two exclusive products, studied for
the cleaning and the maintenance of the
plate: on how to use them please read the
instructions written on the bottles.
To remove the plate, you have to lift it up.
When you reinsert the plate, keep in mind
to leave the 1 or 2 millimetres to allow the
thermal expansion of the plate itself.
insert the new lamp and finally screw in the
lamp cover. Seldom, it is necessary to clean
the glass of the lamp cover. To make this,
you have to unscrew the lamp cover, remove
the external residuals due to the cooking
steams, wash the lamp cover and once it is
dry you can screw it in its place.
97