Rizzoli S Manuel D'utilisation page 98

4.3 USE OF THE CLEANING DOOR (S 80, S 90)
To allow the removal of the residuals of
the combustion also from the less acces-
sible zones, the S 80 and S 90 models are
endowed with a cleaning door under the
4.4 USE OF THE MOVABLE LAYER (S 60 CF)
To allow the removal of the combustion re-
siduals also below the oven, the model S 60
CF is endowed with a movable layer inside
the oven.
To start the cleaning, lift the layer and then,
using the scraper, remove the carbon residu-
4.5 CLEANING THE VISIBLE PARTS
Stainless steel parts have to be cleaned cold
with neutral detersives or with a specific
solution for stainless steel in case of hard
to remove dirt. Do not use at all abrasive
sponges that may scratch the surface. Dry
with a soft rag, following the glazing wise.
In some cases, after the installation or af-
ter the cooking of meals, it might appear a
superficial oxidised stratus, in particular on
the stainless steel frame. Also in this cases,
4.6 CLEANING OF THE GLASSES
The glasses of oven and fire doors may be
washed with normal products in commerce.
The internal part of the fire door has been
made to clean itself during the use of the
WARNING! Do not clean the door before waiting for his cooling. Sudden
changes in temperature may cause the breaking of the glass.
4.7 WOOD BOX
To remove the wood box you should extract
it completely, then lift it up a little and pull it
out at the same time. In this way you access
WARNING! Do not put inflammable products inside the wood box! The ob-
jects inside the wood box must not reach the upper wall of the wood box
oven. To start the cleaning, open the door
unscrewing the fixing pommels, then use
the scraper to clean the carbon residuals:
then, you can close the door.
als and close the door.
The eventual presence of small holes on the
refractory material placed at the basement
of the fume circuit is normal and does not
preclude anyway the working of the cooker.
an accurate cleaning will make the cooker
as new.
On request Rizzoli gives specific products to
clean stainless steel. For enamelled or paint-
ed parts, do not use abrasive and aggres-
sive or acid detersives, in case of stains pour
some oil and wait while it absorbs the halo,
then clean with a soft rag. We recommend
not to use solvents or denatured alcohol on
painted parts.
wood fired cooker. Anyway, sometimes you
could have to clean this part also. For this,
you have to remove the internal glass un-
screwing the 4 screws that block it.
to the lower part of the wood fired cooker.
To reinsert the wood box you can make the
same process reversed.
96