Remote Control Device Installation - TOHATSU MFS 15E Manuel De L'utilisateur

22
INSTALLATION
PT type
1. To attach the outboard motor to the
boat, use the bolts to secure the out-
board motor brackets on transom
board.
5
2
1. Bolt (8 × 85)
2. Washer (small diameter)
3. Nut
4. Washer (large diameter)
a. 30 - 63 mm
View A
ENOW00008-A
Mounting bolts should be installed with
the bolt head at inside surface of the
1
A
4
5
3
a
ENOF00308-1
194
152
187
193
ENOF00305-0
CAUTION
transom. Mounting bolts installed with
the threaded end at the inside surface of
the transom can cause personal injury.
Tighten the bolts sufficiency, otherwise
falling down of outboard could be hap-
pened.
ENON00003-A
Notes
1. Apply sealing material, such as silicone
sealed between the bolts and the tran-
som board holes before tightening the
bolts.
2. Be sure to tighten the mounting bolt
nuts to the specified torque.
(30 N·m (3.0 kgf·m) 13 ft·lb)
ENOM00840-0
2. Remote control device
installation
ENOW00100-B
CAUTION
Be careful not to loop the remote control
cables to a diameter of 406 mm (16 in) or
less. Otherwise, it affects the durability of
the cable.
ENOW00850-0
Remote control box location
1. Shift cable
2. Throttle cable
3. Cable harness B
3
1, 2
ENOF00841-0