In case of water entry
1. Prepare a container under the outlet of
the fuel filter.
2. Loosen the drain screw of the fuel filter.
3. Squeeze the primer bulb several times.
A f t e r t h e w a t e r i s d r a i n e d , s t o p
squeezing.
4. Tighten the drain screw securely and
confirm there is no fuel leaking.
1
3
1. Drain screw
2. Drain port
3. Loosen
4. Tighten
In case of debris
1. If present, disconnect hoses from the
fuel connector (male) and the fuel
pump.
2. Remove the cup, filter and O-rings
from the fuel filter body.
3. Check the wear and clogging for each
parts, and replace if necessary.
4. Remove fuel and any water or debris
from the cup, filter and hoses.
5. Reassemble all parts.
2
4
ENOF01242-1
INSPECTION AND MAINTENANCE
1
2
3
4
5
6
1. Body
2. O-ring
3. O-ring
4. Filter
5. Float
6. Cup
7. Arrow to indicate fuel flow direction
ENOM00096-A
Fuel filter (for fuel tank)
Water or dirt in the fuel tank will cause
engine performance problems.
Check and clean the tank at specified
times or after the outboard motor has
been stored for a long period of time (over
three months).
1. Remove the fuel pickup elbow of the
fuel tank by turning it counterclockwise
2. Clean the fuel filter and check the O-
ring. Replace it if necessary.
3. Reassemble all parts.
63
7
ENOF01243-0
10