TOHATSU MFS 15E Manuel De L'utilisateur page 75

1. Disconnect the fuel hose from the out-
board motor.
2. Remove the top cowl.
3. Loosen the screw (3pcs) of the drive
shaft housing cover on the port side.
ENON00936-0
Note
To avoid losing the bolts, the loosened bolts
cannot be removed.
4. Remove the cowl seal and loosen the
screw (4pcs) of the drive shaft housing
cover on the starboard side.
1
1. Cowl seal
5. Place an approved fuel container
under the drain tube end and use a
funnel to avoid spilling fuel.
INSPECTION AND MAINTENANCE
6. Loosen the vapor separator drain
screw.
7. When thoroughly drained, retighten the
drain screw securely.
8. Check the drained fuel for the pres-
ence of water or other contaminants. If
either is present, reassemble the out-
board motor, refill the vapor separator-
with fuel, and then drain the fuel again.
Repeat this procedure until no water or
other contaminants are present in the
drained fuel.
ENOF01248-0
1. Drain screw
ENOM00102-0
Battery
ENOW00931-A
Place the battery away from any source
of fire, sparks and open flames such as
burners or welding equipment.
Place the battery away from fuel tank.
Accidental sparks of battery may cause
explosion of gasoline.
ENOF01249-0
1. Disconnect the battery cables and be
sure to remove the negative terminal
first.
2. Wipe off any chemical deposits, dirt, or
grease.
1
ENOF01250-0
WARNING
73
10