Overview Notifications - Medela Invia Motion Mode D'emploi

Overview notifications

Visual Notification
symbol Description
on
display
Leak in
system
Blinking!
+
acoustic
signal!
Blockage
Blinking!
+
acoustic
signal!
Canister full
Blinking!
+
acoustic
signal!
Battery low
Blinking!
+
acoustic
signal!
Battery fully
discharged
Blinking!
+
acoustic
signal!
Pump time
expired
Blinking!
(Exam-
ple for
15 days
version)
24
Acoustic signal Troubleshooting
Can be muted Check the system
for 60 seconds for leaks.
by pressing
Can be muted Check the system
for 60 seconds for blockage.
by pressing Verify that the
correct canister is
used:
Can be muted Change the Invia
for 60 seconds Motion canister/
by pressing tubing set.
Can be muted Connect the Invia
permanently by Motion pump to
pressing the power supply
and fully charge
battery. Charging
time can be up to
4 hours.
Can be muted by Connect the Invia
switching off the Motion pump to
pump. the power supply
and fully charge
battery. Charging
time can be up to
4 hours
The blinking Dispose of the
signal can be Invia Motion NPWT
suppressed pump. Attach
permanently by another device if
pressing necessary.
Remarks/Potential
cause
Dressing could be
leaking, check that it is
properly sealed.
The dressing or canister
tubing could be twisted,
kinked or clamped. If
the Invia Motion pump
detects blockage in the
087.4016. intermittent mode, it will
continue to run in the
on-state until blockage
is resolved.
The filter could get wet
by improper positioning
of the pump (upside
down or display side
down).
The visual symbol blinks
all the time until battery
is fully discharged. The
remaining time of the
battery is approximately
30 minutes.
The remaining time
of the battery is approxi-
mately 10 minutes.
The Invia Motion NPWT
pump provides an addi-
tional safety usage time
of 72 hours. During this
time the Invia Motion
pump can be operated
as usual. A signal will
occur after 72 hours
and the negative pres-
sure will not be maintai-
ned.