Ecolab Versatronic Manuel D'utilisation page 513

PC setup program
Binary outputs
Here the binary outputs of the device can be tested for function. By setting the check mark
in the option fields, the binary outputs are controlled manually on the device with the PC
setup program.
Using the "Set All" "Erase All", can be turned on or off once all the binary outputs.
Go to: On-line parameters è Verify / test (double-click) è Binary outputs tab
Fig. 143: Binary outputs
Binary inputs
Here the binary inputs of the device can be tested for function. The "Read permanent"
button starts a one-time test run, which can be stopped again with the "Stop" button.
During this test run, the binary values of the inputs are continuously read from the device,
and indicated by the check mark in the radio buttons.
"Read once" by pressing the button retrieves and displays the current binary values of the
inputs. Click on the individual binary inputs entries, you can also selectively update the
binary value.
Go to: On-line parameters è Verify / test (double-click) è Binary inputs tab
Fig. 144: Binary inputs
241 417102269 Rev. 2-08.2020