Ecolab Versatronic Manuel D'utilisation page 474

PC setup program
12.7.2 Configuring the connection with assistant
The connection settings assistant supports the user in configuring a new connection.
The assistant is always active after opening the device connection list (set check mark).
It opens each time you want to add a new entry to the device connection list. See
Fig. 104.
The configuration of a new connection "with the assistant" is the preferred
method. It is also applicable by a user without expert knowledge.
Setup dialogue - equipment and type of connection
Fig. 104: Device and type of connection
Settings
setting point
Device version
Connection presets
Description
Set as default device from
the connection list
Check whether a connection
can be established
( 1 ) Ring buffer = export measurement data
After clicking "Next", the assistant opens the next setup dialogue.
417102269 Rev. 2-08.2020
Selection / option
Select from drop-down list
Setup or ring memory via
TCP/IP
Setup or ring memory (1)
Over HTTP Proxy
Connection via USB
Text
Control box
Control box
202
Explanation
Device version of the device to be connected
See Ä Chapter 10.7 'Device info' on page 182
LAN interface (HTTP protocol) Connection to
the device within an intranet (or VPN)
LAN interface (HTTP protocol) connection to the
device through proxy servers and Internet
USB interface
Description of the connection
Default devices are accessible automatically,
other devices must be connected via the device
connection list.
With this option ON, you can check if the
selected device can be accessed via the
selected interface.