Burkert 8025 Notice D'utilisation page 54

3 INSTALLATION
3.6 Electrical Wiring of Wall-mount Version
Open the cover to access to the terminals. Wire according to transmitter version and to
following figures.
(*)
1
8020
3
Fig. 3.12 8025 without relays and with power supply 12...30 VDC
Note: For wiring see also § 3.4.1
(*)
1
8020
3
Fig. 3.13 8025 without relays and with power supply 230/115 VAC
Warning: Check position of power supply selection switch (see fig. 3.4) before
!
starting the device.
Note: When current output is used, remove the strap. A switch enables to select the power
supply between 230 and 115 VAC (see fig. 3.4).
8025 - 8025RR
(*)The dotted link between 8020/8030 and 8025 is
2
not necessary for 8020/8030 with coil.
mA
+
-
Strap
2
(*)The dotted link between 8020/8030 and 8025 is
not necessary for 8020/8030 with coil.
E-17-
FLOW TRANSMITTER 8025
N L1
230VAC
115 VAC