Burkert 8025 Notice D'utilisation page 58

3 INSTALLATION REED
3.9 Electrical Wiring of Wall-mount Version
Open the cover to access to the terminals. Wire according to transmitter version and to
following figures.
(*)
1
8020
SF01
3
Fig. 3.18 8025 with power supply 12...30 VDC
For wiring see also § 3.4.
(*)
1
8020
SF01
3
Fig. 3.19 8025 with power supply 230/115 VAC
Warning: Check position of power supply selection switch (see fig. 3.4) before
!
starting the device.
Note: For wiring see also § 3.4. When current output is used, remove the strap. A switch
enables to select the power supply between 230 and 115 VAC (see fig. 3.4).
8025 - 8025RR
(*)The dotted link between 8020 and 8025 is not
necessary for 8020 with coil.
Strap
2
(*)The dotted link between 8020 and 8025 is not
necessary for 8020 with coil.
2
Strap
FLOW TRANSMITTER 8025
Relay Reed
pulse output
Relay Reed
pulse output
E-21-
8025 REED
8025 REED