Installation - Burkert 8025 Notice D'utilisation

3 INSTALLATION

3.2 Installation
Compact version (see fig. 3.2)
The compact flow transmitter 8025 can be
easily installed into pipes using our specially
designed fitting system (types S020,
1500,1501).
1.The fitting 4 must be installed into the
pipe according to the installation
specifications in section 3.1.
2.Insert plastic nut 3 into fitting and let
plastic ring 2 snap into guide bush 5.
3.Carefully insert transmitter 8025 1 into
fitting. If installed properly, the transmitter
cannot be rotated.
4.Tighten transmitter housing to fitting with
plastic nut 3.
Caution! Plastic nut must only be
!
tightened by hand!
Installation of the 8025 panel version
(see fig. 3.3)
For the cut-away of the front panel, follow
the instructions on the delivery enclosed film.
For sensor installation, please consult 8020/
8030 instruction manual. Install device as
follows:
1. Put gasket 2 on the cover 1 and place
the complete unit in the panel cut-away.
2. Screw the spacer bolts 3 on the panel
crossing screws 4.
3. Insert the cable clips 10, to hold the
different cables (power supply, outputs,
sensor) of the transmitter, into plate 7.
4. Plug connector 5 on socket 6 and fasten
plate 7 with screws 9 on bolts 3. Do
not forget the lockwashers 8.
8025 - 8025RR
FLOW TRANSMITTER 8025
Fig. 3.2 Installation of 8025 compact
E-11-