Inserting The Batteries - Reely Piper J3 Cub Notice D'emploi

Attention, important!
In contrast to the control lever for the rudder and elevator function, for which the lever is kept in the centre
position by spring force, the control lever for the motor function will always stop in the last position set.
Therefore, the control lever for the motor function must be put in the centre position before the mode
switch is operated. To prevent the drive motor of the model from starting up unintended, neither the transmitter
nor the model must be in operation during mode switching.
b) Inserting the Batteries
Important!
Only operate the remote control transmitter with batteries with a voltage of 1.5 V/cell. Rechargeable batteries
(NiCd/NiMH) only have a voltage of 1.2 V/cell and therefore are not suitable for power supply to the
transmitter or the charge function that is integrated in the transmitter.
Proceed as follows to insert the batteries:
The battery compartment lid (1) is located on the back
of the transmitter. Push the locking lever (2) at the upper
edge of the battery compartment lid slightly down and
lift off the lid.
Now put the 4 batteries in the battery compartment.
Observe the correct polarity of the individual cells. A
corresponding note (3) is located on the bottom of the
battery compartment.
Then place the battery compartment lid with the bottom
edge first into the transmitter housing and let the
latching lever latch properly when pushing on.
Figure 4
41