Reely Piper J3 Cub Notice D'emploi page 51

If the control stick for the elevator function (see figure 2, item 4) is moved up, the elevator must deflect to the top. The
rear rudder edge must be deflected downwards by approx. 4 - 5 mm. In flight, the landing gear is pressed upwards and
the model dives. This control function is required to put the model into a normal light position if it wants to ascend too
much due to a control error or a gust of wind.
Rudder Function (Mode 1 and 2)
If the control stick for the rudder function (see figure 2, item 4) is moved to the left, the elevator must deflect to the left.
The rear rudder edge must be deflected to the left by approx. 6 – 7 mm. In flight, the landing gear is pressed to the right
and the model flies to the left.
If the control stick for the rudder function (see figure 2, item 4) is moved to the right, the elevator must deflect to the
right. The rear rudder edge must be deflected to the right by approx. 6 - 7 mm. In flight, the landing gear is pressed to
the left and the model flies to the right.
If the rudder does not deflect as described above, the DIP switch at the transmitter must be used to change
the running direction of the servos. More information on this can be taken from the following section:
„Setting the DIP switches".
Figure 16
Figure 17
Figure 18
51