Using The Transmitter; Inserting The Batteries - Reely Redfox Notice D'emploi

9. Using the transmitter

The numbers used in these instructions refer to the illustration alongside the text or the illustrations within
the respective section. For this reason, the same number can represent different locations and different
controls in different figures. Cross-references to other figures are given in the text with the corresponding
figure number.
The figures of the remote control and the model in these operating instructions are for illustrative purposes
only. The label, design and colour scheme of the products supplied in series may differ completely from the
figures in these operating instructions.
a) Inserting the batteries
The transmitter is supplied by 4 AA/Mignon batteries (not included).
Important:
Use only batteries (1.5 V/cell) and do not use rechargeable batteries (1.2 V/cell) as the power supply for
the transmitter.
Proceed as follows to insert the batteries:
Press the grooved surfaces of the battery compartment
cover (1) with both thumbs and slide the cover downwards.
Insert 4 AA/Mignon batteries according to specifications on
the bottom of the battery compartment (2), observing the
correct polarity. The spiral spring contact (3) must always
be connected to the negative pole of the battery.
Then replace the battery compartment cover and push it
upwards until it clicks into place.
38
Figure 2