Checking The Control Functions - Reely Piper J3 Cub Notice D'emploi


15.

Checking the Control Functions

Before starting your model for the first time, you need to familiarise yourself with the control functions and test the
model functions.
Switch on the transmitter first and connect the flight battery to the model.
Neutral Position:
When the control lever for the rudder and elevator function and the digital trimming of the two control functions precisely
in the centre position, the rudder (1) and elevator (2) should be precisely at the centre as well. Viewed from the rear,
the rudders must form a level with the rudder and must not be deflected to the top or bottom, left or right.
If the rudders are not aligned precisely, the bend in the linkage wide may be used to correctly align the rudder. The
bend can be compressed or expanded as required. Use small long-nose pliers or tweezers and work with the required
dexterity.
Figure 11
Figure 12
49