Renewing The Transmitter/Receiver Binding - Reely Piper J3 Cub Notice D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles


13.

Renewing the Transmitter/Receiver Binding

To ensure that 2.4 GHz remote controls can transfer their signal without interferences, the transmitter and receiver
must have the same digital code. Alignment of the digital encoding (binding between transmitter and receiver) is
performed with the binding function.
Transmitter and receiver are usually already aligned with each other or bound in the factory and can be used at once.
Binding only needs to be performed again after replacing the transmitter or receiver or to remove malfunctions.
Since different manufacturers use different encoding methods, transmitter and receiver cannot be combined and
operated with products of other manufacturers.
Re-establishing the binding:
1. Push onto the left contort lever from the top with
the transmitter switched off and hold it in this
position.
2. Switch on the transmitter with the control lever
pushed and then release the control lever.
The transmitter switches to binding mode and issues
a signal sound at a rhythm of seconds for 20
seconds.
The function control display at the transmitter flashes
at the same time.
3. Connect the flight battery to the model during the
binding phase of 20 seconds.
During the binding process, the LED in the model
lights up and the electronics issues double signal
sounds at regular intervals.
After the end of the 20 seconds, the binding phase
is completed and the transmitter and model enter
regular operating conditions.
Finally, check correct function of the remote control
system.
Figure 9
47

Publicité

Table des Matières
loading

Table des Matières