Basic Settings Of The Digital Trim - Reely Piper J3 Cub Notice D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles


14.

Basic Settings of the Digital Trim

Before testing the control functions at the model, you
must review the current position of the digital trimming
or set it correctly.
The remote control transmitter has four trimming
buttons (also see figure 2, item 5, 6, 9 and 11), with the
help of which the „electronic centre position" of the two
control levers can be corrected.
When the model tends to fly to the left all the time later,
for example, you may set the rudder wit the rudder
trimming later so that the model flies straight again.
The trimming can be set during the flight.
Every short push on the trimming buttons makes the
Figure 10
remote control issue a short signal sound that becomes
higher or lower depending on the movement direction
of the trim button.
If the trim button is deflected and held, the sound is issued at a quick sequence.
When the centre position is reached, a double signal is issued. The end of the respective setting area is signalled with
a longer signal sound. The entire trimming path is approx. 30 single steps.
Put all four trim buttons to the centre position now.
48

Publicité

Table des Matières
loading

Table des Matières