9. Commissioning
a) Open/Remove Car Body
Pull the safety clips out and take off the car body upwards.
b) Installing the Receiver Aerial Cable
First open the car body (see chapter 9. a). Guide the aerial
cable through the enclosed aerial tube (A) and plug it into
the respective holder (B) at the top of the vehicle.
For a wide range, the aerial needs to protrude from the
vehicle as vertically as possible.
Never coil the aerial cable! This greatly reduces the range.
Ensure that the aerial cable is not damaged. Never shor-
ten the aerial cable!
c) Inserting Batteries/Rechargeable Batteries into the Transmitter
Open the transmitter's battery compartment and insert either batteries or fully charged rechargeable batteries. Obser-
ve correct polarity (plus/+ and minus/-), see label on the battery compartment. Close the battery compartment again.
Observe the enclosed operating instructions for the remote control system.
d) Taking the Transmitter into Operation
Switch on the transmitter and put the trimming for steering and driving functions into the centre positions. If the trans-
mitter has a dual rate function, deactivate it or set it to unlimited steering deflection.
Observe the enclosed operating instructions for the remote control system.
43