Publicité
2.5.2 Component Boxes cont.
ITEM
PART #
1
8101164
2
8160217
√ 3
8073843
8073293
√ 4
8075008
*
8075009
*
8075266
*
8073484
5
8074199
6
8066085SP
7
2206102
√ 8
8072971
√ 9
8071006
√ 10
8073366†
√
8073365†
√ 11
8262264
8074330
8074343
√ 12
8070833
√ 13
8070834
14
8102243
15
1081094
16
8242090
17
8242091
18
2207085
19
1081544
20
8074812
8074934
21
1060531SP
*
8072659
*
8074403
22
1081260SP
1082353
23
8064973
24
8071683
* Not illustrated.
√ Recommended parts.
† For Full-vat units, use one 8073366 Dual Spark Ignition Module (see NOTE 1).
† For Dual-vat units, use two 8073365 Single Spark Ignition Modules (see NOTE 1).
NOTE 1: Domestic U.S. and Non-CE Export except Australia units use two different modules depending upon
the configuration of the frypot. Full-Vat units use one 8073366 Dual-Spark Ignition Module while Dual-Vat units
use two 8073365 Single-Spark Ignition Modules. Also, in full-vat units, only two latch relays (Item 12) are used,
located in the sockets on the right side of the interface board. These relays are located in the bottom sockets of the
interface board and control the heating circuit.
NOTE 2: The relays in the top sockets control the oil level sensors.
Block, One-Piece Screwless Terminal
Insulation, Terminal Block Paper
Fuse 3A 250V Domestic
Fuse 5A 125V International Only
Cable, 21-inch Ignition – For 8073366/8073365 Modules
Cable, Ignition 19" (CE)
Cable, Ignition, Australian units
Connector, Rajah
Cable, 20-pin Computer to 15-pin Interface Board - SMT
Wire Assembly, Ignitor
Box, One-Piece Component
Ignition Module, (Australia)
Ignition Module, CE
Ignition Module, Dual-Spark Full-Vat (Domestic and Non-CE export unit except
Australia)
Ignition Module, Single-Spark Dual-Vat (Domestic and Non-CE export unit except
Australia)
Interface Board Kit SMT
Speaker Adapter Harness SMT
Wire Harness, SMT Interface Board to Ignition Module
Relay, DPDT 5A 12VDC Latch (See NOTE 1.)
Relay, SPDT 15A 12VDC Oil Level Sensor (See NOTE 2.)
Spring, Relay Retaining
Plate, Ignition Module
Cover, Ignition Module
Cover, Ignition Module CE
Cover, Ignition Module Australia
Plate, Ignition Module Australia
Relay, 7-second Time Delay 120V (U.S., Canadian and Mexico units)
Relay, 7-second Time Delay 220V, 230V, 240V and 250V units (International units)
Fuse Assembly, Inline (not used on all models)
Switch, Momentary (Control Power Reset, only used in far left component box)
Speaker SMT
Wire Assembly, Ignition Module Domestic and Non-CE export, except Australia.
Wire Assembly, Ignition Module CE
Interface Board – Australia Only
Relay, 12VDC Reset Switch
COMPONENT
2-6
Publicité
Dépannage
