Entering Preformatted And User-Defined Traceability Data; Entering Or Changing The Job Number; Entering Or Changing Additional Data - Hürner HCU 300 Manuel Utilisateur

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
6.1 Entering Preformatted and User-defined
Traceability Data
All traceability data enabled in the configuration menu at
"Data Recording" (see Sect. 10) have to be entered before
the welding process. The welding unit prompts the user to
enter them either before or after entering the fitting bar
code (see Display 2). Depending on what data is entered,
either its repeated input is mandatory (e. g., the welder
ID code; see Sect. 5.2) or previously entered data can be
changed and confirmed or confirmed without changes
(e. g. the commission number and the additional data; see
Sect. 6.2, 6.3).
Certain traceability data can also be accessed quickly, via
a selection screen, by pressing the  cursor key (see Dis-
play 6), either for viewing or for entering or changing/
confirming them.

6.2 Entering or Changing the Job Number

The commission number input screen is shown by the unit
before welding or accessed by the user in the quick access
screen (Display 6). It can be entered using the alphanumeric
keypad (see Info in Sect. 5.2) or by reading it from a bar
code using the scanner. The maximum length is 32 char-
acters. Confirm your input by pressing the START/SET key.
The job number will be saved to memory and will appear
in the printed welding report.

6.3 Entering or Changing Additional Data

The additional data input screen is shown by the unit
before welding, first the screen that allows entering the
first additional data, then the one for the second additional
data. This input can be entered either using the alphanu-
meric keypad (see Info in Sect. 5.2) or by reading from a
bar code using the scanner.
For the first additional data input, the maximum length
is 20 characters. For the second data input, the maximum
length is 15 characters. Confirm your input by pressing
START/SET. The additional data will be saved to memory
and appear in the welding report. By pressing STOP/RESET,
you skip this screen without any input.
You are free to define any additional data you
see fit. For instance, you can put into these fields
information on pipe length, ditch depth, or com-
Info
ments that help with welded joint traceability.
Version March 2016 HÜRNER HCU 300 User's Manual
*** Recording ***
Welder Code
>Commission Number
Display 6
Enter Job No.
********************
************
Display 7
Enter Add. Data 1
********************
Display 8
EN
13