Check-Out And Operation; Turning The Welding Unit On - Hürner HCU 300 Manuel Utilisateur

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
microprocessor-controlled HCU 300 Welding Unit
• controls and monitors the welding process in a fully
automated fashion,
• determines welding duration depending on ambient
temperature,
• shows all information on the display in plain text.
All data that are relevant for the weld or for traceability
are saved to the internal memory and can be sent to a
USB stick.
Welding data transfer is enabled through an interface of
the USB A type, which is compatible with a USB stick.
Further Optional Accessories
• PC software for downloading and archiving data on
PC (for all common Windows operating systems)
• USB stick for data transfer from the welding unit on
the worksite to the printer or PC in your office (see
details at the end of this booklet)
5

Check-out and Operation

• To operate the welding unit, be sure that it is set on a
proper, level surface.
• Be sure that power supply/generator protection is 16 A
(slow blow).
• Plug the power supply cord into the mains power
supply or the generator.
• Read and comply with the User's Manual of the gen-
erator, if applicable.

5.1 Turning the Welding Unit on

After connecting the power supply cable to mains power
or a generator, turn the welding unit on using the On/Off
switch. This causes Display 1 to show.
Then the screen changes to Display 2.
CAUTION in case of System Errors!
If during the auto-test that the unit performs at
start-up, an error is detected, a "System Error" mes-
Caution
sage shows on the display. When this happens, the
welding unit has to be disconnected immediately
from the power suppy and the fitting, and it has
to be shipped to the manufacturer for repair.
Version March 2016 HÜRNER HCU 300 User's Manual
********************
HUERNER
HCU 300 2.0
********************
Display 1
Enter Fitting Code
14:32:22 21.10.12
Inp.Volt. 230V 50Hz
No Contact
Display 2
EN
9