Entering Preformatted And User-Defined Traceability Data - Hürner CNC ECO 315 2.0 Manuel Utilisateur

page de 196

/ 196
Matières
Table des Matières
Signets

Table des Matières

Les langues disponibles

before every new welding, "off" that the user is not

prompted to enter it.

"Joint Number on" means that the systems assigns an au-

tomatically incremented joint number to every welding

operation belonging to a commission already known,

and displays this number on the screen next to the re-

port number, "off" that no joint numbers will be as-

signed at all.

"Additional Data on" means that the additional data will

have to be entered or confirmed before every new weld-

ing, "off" that the user is not prompted to enter them.

"Fitting Code on" means that the second, so-called trace-

ability code of the pipeline fitting that is going to be

worked has to be entered before every welding, "off,"

that this is not possible.

"Pipe Codes on" means that the codes of both pipes/compo-

nents (ISO-compliant welding and treaceability codes)

have to be entered before every welding, "off," that

this is not possible.

"Pipe Length on" means that the length of both pipes/com-

ponents has to be entered before every welding, "off,"

that this is not possible.

"Weather Conditions on" means that the weather has to be

selected in a list before every welding, "off," that this

is not possible.

"Geo-data on" means that the geographic coodinates have

to be recorded after every welding (see Sect. 4.4 for de-

tails), "off," that this is not possible.

"Installing Company on" means that the company that per-

forms the installation work has to be entered before ev-

ery welding, "off," that this is not possible.

"HCD on" (short for "half cooling time displayed") means

that for a welding operation in the workshop with the

cooling time reduced to 50 % of its statutory duration

by pressing the START/SET key, the indication "-HC-" will

be included in the report (refer to Sect. 4.3.8), "off,"

that nothing will show up in the report even when the

cooling time was halved.

"Print Tags – M – " means that by pressing the MENU key,

the user can access a sub-menu for starting to print (a)

label(s) with reference to a given welding operation, us-

ing the optional label tag printer.

All data that are available in the chip of a transpon-

der card can be entered by placing the card in front

of the RFID reader. If they are encoded in a bar code,

Info

they can be read using a handheld scanner.

4.2