Resetting The Cycle Counter To Zero - Hettich EBA 280 Mode D'emploi

20.9

Resetting the cycle counter to zero

After the rotor/hanger has been exchanged, the cycle counter of the respective rotor code must be reset to zero
again.
The cycle counter may only be reset to zero if the rotor/hanger has been exchanged for a new rotor/hanger
first.
With the rotor at a standstill, the cycle counter can be reset as follows:
The procedure can be aborted at any time by pressing the
 Press and hold the button for eight
seconds.

 Press the key until the following is
displayed:

 Press the key.
START
PULSE

 Press the key until the following is
displayed:
Cyc sum : Number of completed run
cycles.

 Press the key.
RCF

 Press the key.
The number of completed run cycles is
reset to zero.

 Press the key to save the setting.
START
PULSE

 Press the key twice to exit the "
STOP
Cycles" menu or press three times to exit
OPEN
the " MACHINE MENU ".
AB1101DEENFRIT
STOP
key. In this case, the settings are not stored.
OPEN
PROG RPM
PROG RPM
Example:
PROG RPM
PROG RPM
PROG RPM
PROG RPM
PROG RPM
PROG RPM
Time &
PROG RPM
Rev. 03
t/min:s
t/min:s
t/min:s
t/min:s
t/min:s
t/min:s
t/min:s
t/min:s
Example:
t/min:s PROG RPM
EN
t/min:s
77/166