Operating And Display Elements; Displayed Symbols; Control Panel Keys - Hettich EBA 280 Mode D'emploi

EN
14

Operating and display elements

PROG
PROG RCF
14.1

Displayed symbols

Lid unlocked.
Lid locked.
Rotation display. The rotation display lights up, rotating counter clockwise, as long as the rotor is turning.
14.2

Control panel keys

 Calling up programs
PROG
 Save program.
 Switching between the RPM display (RPM) and RCF display ( RCF ).
RCF values are displayed in parentheses
RCF
The LED above the key will light up if the RCF display is activated.
RPM Speed
RCF : Relative centrifugal acceleration
 Selection key for activating the individual parameters.
Every time the key is pressed, the next parameter is activated.
 Call up the "MACHINE MENU" (keep the key pressed for 8 seconds).
 In the "Machine Menu", select the menus "
 Scroll forward in the menus.
 Change the value of a previously selected parameter.
If the key is kept pressed, the value changes with increasing speed.
 Start the centrifugation run.
START
The LED in the key will be illuminated during the centrifugation run as long as the rotor is turning.
PULSE
 Short-term centrifugation.
Centrifugation is run as long as the key is kept pressed. The LED in the key will be illuminated during
the centrifugation run as long as the rotor is turning.
 Save inputs and changes.
 Call up the menus "
 Finish the centrifugation run.
STOP
The rotor runs down with a pre-selected brake stage. The right LED in the button is illuminated until
OPEN
the rotor is still. After the rotor stops, the left LED in the key will light up.
Pressing the key twice triggers the Emergency Stop.
 Unlock the lid.
The left LED in the key will go out.
58/166
RPM t/min:s
Info", " Settings" and "
Rev. 03
START
PULSE
STOP
OPEN
.
Info", " Settings" and "
Time & Cycles".
Time & Cycles".
AB1101DEENFRIT