Acoustic Signal - Hettich EBA 280 Mode D'emploi

EN
20.2

Acoustic signal

The acoustic signal sounds:

after a malfunction occurs in a 2-second interval.

after ending the centrifugation run and the rotor is at a standstill in a 30-second interval.
The acoustic signal is ended by pressing any key.
If the rotor is at a standstill, the acoustic signal can be set as follows:
The procedure can be aborted at any time by pressing the
 Press and hold the button for eight
seconds.

 Press the key until the following is
displayed:

 Press the key.
START
End beep : Acoustic signal after ending
PULSE
the centrifugation run.
off : Signal deactivated.
on : Signal activated.

 With the keys, set off or on.

 Press the key.
Error beep : Acoustic signal after a
malfunction occurs.
off : Signal deactivated.
on : Signal activated.

 With the keys, set off or on.

 Press the key.
Beep volume : Volume of the acoustic
signal.
min : soft
mid : medium
max : loud

 With the keys, set min, mid, or max.

Continued on next page
70/166
STOP
key. In this case, the settings are not stored.
OPEN
PROG RPM t/min:s
PROG RPM t/min:s
PROG RPM t/min:s
PROG RPM t/min:s
PROG RPM t/min:s
PROG RPM t/min:s
PROG RPM t/min:s
PROG RPM t/min:s
PROG RPM t/min:s
PROG RPM t/min:s
Rev. 03
PROG RPM t/min:s
PROG RPM t/min:s
PROG RPM t/min:s
PROG RPM t/min:s
PROG RPM t/min:s
PROG RPM t/min:s
AB1101DEENFRIT