Sulky Vision CAN 20 DPB Notice Originale page 55

Start-up
A
Start-up
a) menu
- 1 -
Select the menu.
- 2 -
Check that all the parameters have been saved correctly: speed sensor
- 3 -
Select your fertiliser.
N
OTE
You can now fill the hopper of the fertiliser spreader.
b) menu.
- 1 -
Select the menu.
- 2 -
Select the PAR/TOT menu.
- 3 -
Reset each counter to zero using the RAZ function
- 4 -
As soon as the alarm goes off and the bell is displayed on the screen, select
- Select OK to return to the main screen.
- 5 -
Select if you wish to save your work.
c) menu.
- 1 -
Select the menu.
- 2 -
Check: • that the fertiliser selected is correct,
• that the hydraulic shutters are well closed,
- 3 -
Select and perform a static calibration test.
- 4 -
Select your application rate per hectare:
- use the numeric keypad directly, validate with
- 5 -
Your spreading is DPA.
You can adjust your dose/hectare: select
- 6 -
You may adjust either the right side selecting
- 7 -
You may enable the Tribord.
.
or then return to initial rate selecting
or the left side selecting
and working width .
to find out the reasons.
.
.
GB
3
55