Carriage Lock; Manual Operation; Turning With Automatic Feed - HOLZMANN MASCHINEN ED400FD Manuel D'utilisation

19.4.8 Carriage Lock

Carriage lock screw must be unlocked before engaging automatic feeds or damage to
lathe may occur!

19.4.9 Manual Operation

The lathe slide is moved by the handwheel (18), the cross slide by the handwheel (17) and the
top slide by the handwheel (15).
19.4.10

Turning with Automatic Feed

By turning on the lathe at a high speed dial and activated A-release lever, the saddle
is moved at high speed.
The clamping of the lathe slide must be unlocked before you turn on the automatic
feed!
Use the tables to select and set the desired feed rate or speed.
If necessary, change the gear wheels. The combination of the gears is indicated in the threading
table.
HOLZMANN MASCHINEN GmbH
NOTICE
For manual operation, the bed slide can be clamped as follows:
 Turn hex socket cap screw (A) clockwise and tighten to lock.
 Turn counter-clockwise and loosen to unlock.
CAUTION
HINWEIS
Automatic longitudinal feed:
 Press the feed/thread engagement lever (16) downwards to switch
on the automatic longitudinal feed.
 If the lever is pulled upwards, the automatic longitudinal feed is
stopped.
www.holzmann-maschinen.at
OPERATION
53
ED400FD | ED400FDDIG