Safety Devices; General Safety Instructions - HOLZMANN MASCHINEN ED400FD Manuel D'utilisation

16.3

Safety Devices

The machine is equipped with the following safety devices:
16.4

General Safety Instructions

To avoid malfunctions, damage and health hazards when working with the machine, the following
points must be observed in addition to the general rules for safe working:
 Before start-up, check the machine for completeness and function. Only use the machine if
the guards and other non-parting guards required for machining have been fitted, are in
good operating condition and have been properly maintained.
 Choose a level, vibration-free, non-slip surface for the installation location.
 Ensure sufficient space around the machine!
 Ensure sufficient lighting conditions at the workplace to avoid stroboscopic effects.
 Ensure a clean working environment.
 Only use perfect tools that are free of cracks and other defects (e.g. deformations).
 Remove tool keys and other adjustment tools before switching on the machine.
 Keep the area around the machine free of obstacles (e.g. dust, chips, cut parts, etc.).
 Check the strength of the machine connections before each use.
 Never leave the running machine unattended. Switch off the machine before leaving the
working area and secure it against unintentional or unauthorised recommissioning.
 The machine may only be operated, serviced or repaired by persons who are familiar with
it and who have been informed of the hazards arising from this work.
 Ensure that unauthorised persons maintain a safe distance from the machine and keep
children away from the machine.
 When working on the machine, never wear loose jewellery, loose clothing, ties or long,
open hair.
 Hide long hair under hair protection.
 Wear close-fitting protective clothing and suitable protective equipment (eye protection,
dust mask, ear protection; gloves only when handling tools).
 Metal dust can contain chemical substances that can have a negative effect on health.
Work on the machine should only be carried out in well-ventilated rooms. If necessary,
use dust protection.
 If there are connections for dust extraction, make sure that they are properly connected
and in working order.
 Always work with care and the necessary caution and never use excessive force.
 Do not overload the machine!
 Shut down the machine and disconnect it from the power supply before carrying out any
adjustment, conversion, cleaning, maintenance or repair work. Before starting any work
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
 a jaw chuck guard with position switch.
The machine can only switches on
when the guard is closed.
 a protective cover for gearbox with
microswitch.
 a spiral spring as a protective cover on
the lead screw to prevent clothing from
being drawn in.
SAFETY
44
ED400FD | ED400FDDIG