Fastening The Digital Read Out (Only For Model Ed400Fddig); Aligning The Lathe; Checking The Jaw Chuck - HOLZMANN MASCHINEN ED400FD Manuel D'utilisation

Masquer les pouces Voir aussi pour ED400FD:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

18.1.4 Fastening the Digital Read Out (only for model ED400FDDIG)

18.1.5 Aligning the Lathe

18.1.6 Checking the Jaw Chuck

When mounting a chuck or face plate, first make sure that the cam-lock studs are
properly fixed. Otherwise, the chuck/face plate may never be removed again later
because the cam-lock studs have become twisted.
HOLZMANN MASCHINEN GmbH
After installation and commissioning, it is recommended to check
the alignment and levelling of the machine before using it for the
first time. In order to ensure working accuracy, the alignment and
levelling should be repeated at regular intervals.
To level the machine, use a precision spirit level according to DIN
877 with an accuracy of ±0.02 mm or ±0.04 mm to 1000 mm. This
allows the horizontal position of the machine axis to be checked with
sufficient accuracy in both the longitudinal and transverse
directions.
Repeat the horizontal check a few days after initial commissioning
and every six months thereafter.
NOTICE
Do not use cast iron chucks. Use ductile iron chucks only. Before
disassembling the jaw chuck, place a stable board or chuck cradle
under the spindle to protect the precision-ground surfaces.
NOTICE
www.holzmann-maschinen.at
The digital read out (DRO) has to be mounted
onto the machine before usage (see picture on
the left). and the cables have to be connected
via the plug connections.
ASSEMBLY
48
ED400FD | ED400FDDIG

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ed400fddig

Table des Matières