BMW Inline Instructions De Montage page 119

3. 1 2.3 To operate the system with the time switch (optional)
Figure F
To switch on the auxiliary heating system
Manual: Press the Heat immediately
Automatic: Program the heating start time
Operating indicator
The Heating indicator
To switch off the auxiliary heating system
Manual: Press the Heat immediately
Automatic: By the heating time programmed using the time switch.
The Heating indicator
If the auxiliary heating system was switched on using the Telestart remote control, the auxiliary heating system can
be switched off by pressing the Heat immediately
To set the time
Press the Time button (105) briefly, then press "Forwards"
time is displayed.
Release the button again.
The longer you hold the button, the faster the clock will run.
To call up the time
Press the "Time" button
To program the heating start time
Three different start times can be programmed.
Press the button (107) once and program the first start time as follows.
Set
"-:--" or a time will appear on the display (103).
Press "Forwards" or "Backwards"
start time will be deleted from the display after approx. 8 seconds.
If you do not press "Forwards"
selected and saved.
Press the button (107) again to program the other start times.
Set
The heating start time is programmed if the program number (104) is displayed and the orange indicator light
is lit permanently.
The brightness of the display cannot be adjusted.
To delete a selected time
Press the button (107) briefly.
Set
The start time in the display (103) will disappear.
To select a programmed time
Press the button (107) within 10 seconds until the program number with the required time is displayed.
Set
3-76/EN
button (101)
(102) and the orange indicator light will be lit throughout the heating time.
button (101)
(102) and the orange indicator light will go out.
(105) briefly.The display will go out after 10 seconds.
(108) until the required time is shown in the display (103).The heating
or "Backwards"
() button (101) twice.
(106) or "Backwards"
() (108) for over 10 seconds, the displayed time will be
(108) until the desired