Circuit Diagrams - BMW Inline Instructions De Montage

1 Important information
(For use within the BMW dealer organisation only)
Installation time approx. 5 - 6 hours
The installation time may vary depending on the condition of the car and the equipment in it.
Target group
The target group for these installation instructions is staff who have been trained on BMW cars.
Work
All servicing, repair, installation and adjustment work on cars is completed at your own risk.
– Repair instructions,

– Circuit diagrams,

– Servicing manuals,
– Work instructions,
– Diagnostics manuals
in a rational sequence using the prescribed tools (special tools) and pursuant to the relevant health and safety
regulations.
Drilling instructions
Deburr drilled holes and treat them with the usual BMW anti-corrosion work. Remove all drill chippings.
Safety notes
Please read the following before starting the installation work.
If the specified PIN slots are already in use, bridges, double crimps or parallel end stops are to be used. All work is
shown for a left-hand drive model.
All hose lines and cables are to be installed in such a way that they cannot chafe or sag.
All wiring harnesses are to be installed in such a way that they cannot be kinked, chafed or crushed.
The vehicle must not be operated in enclosed areas such as garages or workshops without a fume extrac-
tion system (not even with the timer or using the remote control).
The auxiliary heating system must be switched off at filling stations.
Important information on operation
To avoid starting problems caused by using the auxiliary heating system, you should not use the auxiliary heating
system if you only drive the car for short distances (< 20 km).
EN/1-5