BMW Inline Instructions De Montage page 85

Figure G
Fit the piping (19) to act as a chafing guard on the holder (85) below the headlights on both sides and on the
left-hand side member (84) as shown.
Figure H
Remove the nuts (86) and washers, insert the holder (13) and secure it with the nuts (86) and washers.
Figure I
Connect the auxiliary heating system harness A to the assembled auxiliary heater (12), insert the auxiliary heater
and secure it to the holder (13) with the self-tapping screws (42).
Align the holder (14), mark the hole for the rivet nut (41) on the wheel arch (87), drill the hole with a 9 mm drill bit
and secure the rivet nut (41).
Secure the holder (14) to the wheel arch (87) using the hexagonal screw M6 x 12 (39) and tighten the self-tapping
screw used to secure the holder (14) to the auxiliary heater (12).
Connect the exhaust hose (18a) to the silencer (16) using the pipe clip (38) and thread it through the passage
grommet (15) to the outside.
Connect the fuel line (0) to the auxiliary heater (12) using the connector (33) and hose clips (10).
Go back to section 2
3-44/EN