Ammann APR 2220 Traduction Du Mode D'emploi Original page 80

3. Op er a tion
3.10.2 In stal la tion ver sion 2
In jury haz ard from im proper lift ing and trans port.
Crush ing haz ard from fall ing or tilt ing of the ma chine.
For lift ing, only the cen tral point sus pen sion in -
stalled as stan dard is to be used.
Use only suit able lift ing equip ment with ad e quate
load ca pac ity.
Never walk un der sus pended loads.
In jury haz ard from im proper in stal la tion work.
Per form in stal la tion work only with the en gine off,
on level ground, and with the ut most cau tion.
Use per sonal safety equip ment.
Use only per fect tools.
Never use dam aged parts.
Check whether all parts are
– com plete,
– un dam aged,
– and clean.
To en sure that the ma chine runs per fectly, ev ery
5 hours, check the Vulkollan plate and tense it, if
nec es sary.
•
Use a crane to lift the ma chine a bit (about 15–20 cm).
•
Po si tion the pro tec tion plate cen trally un der the ma chine.
•
Lower the ma chine and place it on the pro tec tion plate.
•
Use the grips (1) to pull the pro tec tion plate's straps (2) over
the cor ners of the base plate (3).
•
The ma chine is now ready to use.
74