Charge Battery; Battery Low; Battery Empty - Medela Thopaz Mode D'emploi

3 Charge battery

Battery low

Approximately 30 minutes before the battery is fully empty an acoustic signal sounds and the
battery symbol [ ] starts to blink. The acoustic signal can be muted but the battery symbol
continues to blink until the battery is empty. The set pressure is maintained but the battery
should be recharged as soon as possible.

Battery empty

The battery symbol will blink with an acoustic sound for 10 minutes prior to the battery fully
discharging, unless the pump is switched off earlier. The acoustic sound cannot be muted
during the 10 minutes. If Thopaz is not connected to a power source the system will switch off
automatically after 10 minutes. The negative pressure is not maintained after the system turns off.
1. Battery empty
(sign is blinking)
2. Battery almost empty
Plug the Thopaz Power supply into a wall outlet and open the small
protection cover to access the DC socket. Plug the coaxial power
supply into the DC socket. Moving bars on the battery display will
indicate charging is occurring [
to acknowledge an acoustic alarm (see chapter 13)
Press simultaneously, then follow the instructions on
the display
3. Battery is being charged
(moving bars)
4. Battery is fully charged
].
Charge battery
| 11