Charge Battery - Medela Invia Motion Mode D'emploi

Charge battery

To charge the battery, please follow the instructions below.
1. Select the plug. Attach the plug to the power supply.
2. Open the Direct Current (DC) socket by pulling the small
protective cover open.
3. Connect the small end of the power supply into the Invia Motion
NPWT pump.
4. Plug the large end of the power supply into a wall outlet. The
moving bars on the battery display will indicate that charging is
occurring.
Battery Status Symbols
fully charged
Check the battery charge status periodically. The battery will be
fully charged after approximately 4 hours. Once charged, the
symbol will appear constantly on the display. After charging is com-
pleted, unplug the power supply from the wall and disconnect the
Invia Motion NPWT pump from the power supply. Charging of the
battery can be slowed when exposed to high temperatures. Close
the Direct Current (DC) socket by pressing the small protective
cover over the opening. When the battery is fully charged, it should
half full fully discharged
15