The Ntp Client Software - Gorgy Timing LEDI NETWORK IN Mode D'emploi

1.3.2. The NTP client software

NTP software states
Here are the different states of the NTP client software:
Learning
environment
Here is a description of these states:
► Starting:
The software is starting, it initializes and check the hardware if needed.
► auto-detection:
Server auto-detection is activated. The NTP client tries to find Gorgy Timing ser-
vers. At least one detected server is required to leave this state;
► Learning:
The NTP client software has found one or several Gorgy Timing (auto-detection ac-
tivated) or works with configured servers. In this state, the software learns network
properties. About 2 minutes are required to complete this stage;
Tracking:
►
Normal behavior, the NTP client permanently evaluate its offset and drift with the
server;
► Commuting:
Not enough reply received from current server, trying another server.
58
Searching servers
Auto-detec on
Learning
Enable outputs
Tracking
Star ng
Learning
environment
No reply
Commuta�on OK
MDE-LEDI-NETWORK-IN-4065V1.0
1. INTRODUCTION
Commu ng