Full Setup; Network Configuration; Default Configuration; Changing Network Parameters - Gorgy Timing LEDI NETWORK IN Mode D'emploi

This part contains information for a full configuration of the product. It should be
used for fine network configuration and output cards set-up

2.1. NETWORK CONfIGURaTION

2.1.1. Default configuration

The LEDI Network IN is configured to automatically take an IP address from a DHCP
server. At startup, the product broadcast a DHCP query to get an IP address. This query
contains a DHCP name. There are two cases:
► If a DHCP server is installed on the network, it record the DHCP name and return an
IP address. The LEDI Network IN starts working with this address.
► If no DHCP server is installed, the LEDI Network IN automatically uses a default IP
address in the range 169.254.x.y (where x and y are between 0 and 255).
The default DHCP identifier of the product is CRnnnnnn with nnnnnn, the serial number
on 6 digits. The serial number is written on the identification stamp on the top or on the
bottom of the product.
The default SNMP name of the product (that can be seen from a SNMP browser (see
part 6) or from a WEB browser) is LediNetwkINnnnnnn with nnnnnn, the serial number
on 6 digits.

2.1.2. Changing network parameters

Use the GTNetMng tool provided on the CDROM to configure your device:
Insert the CDROM in the drive. Start the GTNetMng tool that is localized in the
►
directory Common\Configuration
4/ For example, if your CD reader has letter E:, the GTNetMng tool is localized in E:\Common\Configuration\
GTNetMng.exe
MDE-LEDI-NETWORK-IN-4065V1.0
44
2.

fULL SETUP

59