4.3.2 NTP setup
When you click the NTP button, the configuration of the NTP server software of the
output card is displayed as shown below:
Description
Here is the short description of the different fields:
►
STRATUM level
the stratum value to be stored in the NTP messages sends to the NTP clients.
►
Reference ID
A 4 letters identifier that gives information about the time reference. This value is put
in the appropriate field in the NTP frame
Security threshold
►
Give the maximum allowed phase difference (in seconds) before locking the NTP
server software. This field is initialized to 65536.0
80
MDE-LEDI-NETWORK-IN-4065V1.0