The Ntp Client Software - Gorgy Timing LEDI NETWORK TOP Série Mode D'emploi

1.2. thE ntP CLIEnt SOFtwaRE

ntP software states
Here are the different states of the NTP client software:
Searching
servers
Auto-detection
Learning
environment
Here is a description of these states:
► Starting:
The software is starting, it initializes and check the hardware if needed.
► auto-detection:
Server auto-detection is activated. The NTP client tries to find Gorgy Timing ser-
vers. At least one detected server is required to leave this state.
Learning:
►
The NTP client software has found one or several Gorgy Timing (auto-detection ac-
tivated) or works with configured servers. In this state, the software learns network
properties. About 2 minutes are required to complete this stage.
► tracking:
Normal behavior, the NTP client permanently evaluate its offset and drift with the
server.
► Commuting:
Not enough reply received from current server, trying another server.
MDE-LEDInetworkTOP-4092-V1.1
Starting
Learning
environment
Learning
Enable outputs
Tracking
Commutation OK
Error
No reply
Commuting
49