Introduction; Quick Installation; Check The Package Content - Gorgy Timing LEDI NETWORK IN Mode D'emploi

This document is a user's guide for the LEDI Network IN. This product is a NTP client. The
purpose of this device is to synchronize various equipments using a reference time from
one or several NTP servers. You can see this product as a kind of converter that translates
a "NTP signal" to a traditional synchronization signals (ASCII+TOP, AFNOR, IRIG-B for
example).
Using the LEDI Network IN for synchronization provides you with several advantages:
► You can use the installed network architecture with the well-known protocols
Ethernet+TCP/IP
► L'installation est simple.
► You can change Simplified set-up.
► The product is a 19" 1U rack that can be easily installed on your installation.
EBy using a Gorgy Timing server in combination with the LEDI Network IN you greatly
improve the ease of installation and use.
☛

1.1. qUICK INSTaLLaTION

This part contains the minimum information for the set-up of the LEDI Network IN. You can
find additional information in part 3.

1.1.1. Check the package content

The package must contains the following items:
► The product itself: a 19" 1U rack.
• The name of this product is LEDI NETWORK IN which is written on the front
side of the rack.
• The code and configuration of the product can be checked on the identification
stamp put on top or backside of the product. It must be 9257/opt (where opt de-
pends on the output cards – see Erreur ! Source du renvoi introuvable.)..
► A power supply cable (only for 220V AC and 115V AC versions).
► A network cable
► A CDROM that contains set-up and management tools.
☛
Contact your dealer if one of the items above isn't in the package.
MDE-LEDI-NETWORK-IN-4065V1.0
Jump directly to section 1.1 for quick installation
1.

INTRODUCTION

53