Binary Outputs (Default Configuration); Operating Modes Of The Mfc - Burkert 8626 Instructions De Service

Binary outputs (default configuration)

The binary outputs are executed as realy outputs (potential-free changeover
contacts).
Functions
Relay 1 LIMIT (y)
Relay 2* ERROR (serious error, e.g. sensor breakage or faulty internal
voltage supply)
* (not present with 8710/00)
NOTE
The functions of the LEDs (POWER and ERROR LEDs
unchangeable), standard signal inputs and outputs and the binary
inputs and outputs are settings as delivered. Other functions may be
set with the communication software (MassFlowCommunicator –
see Appendix C).

Operating modes of the MFC

Operating can be interrupted
mode or ended by
Standard · Autotune routine
control
· Safety function
operation
· Setpoint profile
· Control operation
Control · Autotune routine
operation
· Safety function
· Setpoint profile
Setpoint profile · Autotune routine
· Safety function
· Device reset
Autotune · Safety function
routine · Device reset
Safety function
LED display
of default
-
LIMIT (y) LED
flashes
LIMIT (y) LED
flashes
POWER LED
flashes
- LIMIT (y) LED
flashes
Reaching the operating
status via binary input
(if configured)
-
as long as activated
Initiate with activated
binary input ≥ 0.5 s
(if continuously
configured, repeated
starts)
Initiate with actifated
binary input ≥ 0.5 s
(if continuously
configured, repeated
starts)
as long as activated
MFC/MFM - 29