AOIP THERMYS 150 Mode D'emploi page 95

Pressing F3 (Memory) gives access to all the memory functions.
RUN:
starts the storage of data as configured using the Parameters function. The icon is shown in the Measurements window.
STOP:
stops the current storage operation.
PARAMETERS
This can be used to define:
the burst size (10,000 values max.),
the sampling period, from 0.5 sec. to 30 min,
and the type of trigger (none, low level, high level).
the same parameters may be selected for both channels (V1 and V2),
the same commands common to both channels (V1 and V2) may be selected
If high-level or low-level trigger is selected, the trigger level and number of data points to be stored after this trigger must be defined.
Burst display:
The burst can be displayed as a table of values or a trend curve.
Block size (2,500 measurements)
Post trigger = 1000 mesures
Trigger on programmed value
= 3°C
Storing the current acquisitions
B
95/107