AOIP THERMYS 150 Mode D'emploi page 91

pour ajouter un point
pour supprimer un point
• Press function key F1 ( ), select the
navigation keys to select the transmission mode.
Definitions of transmission modes:
Manual: the settings are generated under manual control with the user accepting each point,
One-Way: the settings are generated automatically in the order in which the points (Point 1, Point 2, Point3 etc.) are defined,
Two-Way: the settings are generated automatically in the order in which the points (Point 1, Point 2, Point3 etc.) are defined and then in reverse order (Point
n, Point (n-1) etc.).
• Define the quiescent point and press ENTER.
• Define the stability detection.
To define the acceptance conditions:
The unit may be set to display a "Verdict": "OK" or "KO" at the end of the procedure. In this case, set permissible deviation in percent and units (according to
the type of measurement).
Transmission mode, field, press function key F4 (
Calibration procedure
) to open the drop-down menu, and use the Down
B
or Up
91/107