A.6 Powering On; A.7 Measurement On Channel V1 Or V2 - AOIP THERMYS 150 Mode D'emploi

A.6 Powering on
Connect the charger if this is the first time of use. The red LED
off.
To start instrument, press On / Off
After AOIP logo is displayed followed by a window showing EEPROM testing, a screen similar to the one below should appear.
A.7 Measurement on channel V1 or V2
To change the Measurement functions from channel V1, a rectangle should surround the top window on the screen. If it is not the case, select channel by
activating the measurement window with function key F2 (V1).
In order to be able to change the channel C2 measurement functions, there must be a rectangle around the lower window on the screen. If this is not the case,
select the channel by pressing function key F2 (C2) to activate the measurement window.
To choose a measurement function, press key F1 (Menu).
Select the Function ... menu with the navigation keys and confirm with the ENTER key.
Measurement on channel V1 or V2
lights while the battery pack is charging. When batteries are fully charged, red LED goes
key for one second.
A
71/107