Cyclic Ramp Mode - AOIP THERMYS 150 Mode D'emploi

THERMYS 150 A
DVANCED
H: maximum amplitude of the signal.
T: duration of the ramp in seconds.
Delay: delay in seconds between launching the ramp and the start of transmission.
During generation of a simple ramp, a progress bar indicates the state of progress. The function keys are used to control generation:
The key stops generation at any time
The key suspends generation
The key commences or resumes generation
An icon in the transmission window indicates suspended generation.
B.1.5

Cyclic Ramp Mode

The cyclic ramp generation function is used to program a first linear variation in a direction (increasing or decreasing) followed by a first step and then a second
linear variation in a direction opposite to the first variation followed by a second step.
When this mode is active, the
The function key is used to launch an increasing cyclic ramp and the
The default parameters of this mode are displayed in the left hand side of the transmission window. To change these parameters, press ENTER or use the Menu
Mode....
80/107
O
PERATION
icon appears in the transmission window.
function key is used to launch an decreasing cyclic ramp.
Icon indicating that
cyclic ramp mode
is confirmed