AOIP THERMYS 150 Mode D'emploi page 82

THERMYS 150 A O
DVANCED PERATION
Icon indicating that
synthesizer mode is
confirmed
The key is used to launch generation of values in increasing order and the function key is used to launch generation of values in decreasing order.
The default parameters of this mode are displayed in the left hand side of the transmission window.
The parameters of the synthesiser mode are:
First point no.: number of the first point in a cycle
Last point no.: number of the last point in a cycle
T: the duration for which a point is transmitted.
Nbr: the number of polling cycles
Delay: delay between launch and transmission of the first point.
To change these parameters, use the Menu Synthesiser... Parameters...
The number of the first point may be higher than that of the last point. All points between the first and last are generated.
To edit the points to be synthesized, use the Menu Synthesiser... Points....
82/107